home *** CD-ROM | disk | FTP | other *** search
- Kermit-10 now has a lot of patches put into it. The first set of
- patches is based on those submitted by PIMA. The subsequent patches
- are added in order to make Kermit-10 similar to Kermit-32. The last
- patch is to change all the search file names to K10??? as opposed to
- KER???.
-
- 1.0
-
- PATCH [127]
-
- Based on the patches we received from PIMA the following changes
- have been added to KERMIT and KERUNV.
-
-
- 1. Fix IFN stopcode if syntax error in KERMIT.INI.
-
- 2. Add help text for connect mode ESCape commands. Q (Quit) and
- R (Resume) logging
-
- 3. Add SET XON-XOFF-PROCESSING to determine how Xon/Xoff should
- be handled during connect.
-
- 4. Add a new File Byte Size of 36-Bits for 10/20 transfers
-
- These changes are in Modules KERMIT and KERUNV
- Page 2
-
- 2.0
-
- PATCH [130] & [3.1.045]
-
- When attempting to do multiple file sends from Kermit-10, the
- prompt indicating subsequent sends is screwed up. It sends: the sent
- file name, followed by, "as ", "Sending: ", and then, the original
- file name. This is due to the timing of when NEXT_FILE prints the
- "Sending: " prompt. The fix is to take the subsequent file sending
- prompt out of KERMSG and put it into KERMIT. This fixes the problem,
- but it also requires a similar patch to be put into KERMIT-32 and
- PROKERMIT.
-
- Changes were to Modules KERMIT and KERMSG.
-
- 3.0
-
- PATCH [131], [132], & [133]
-
- Make KERMIT-10 look similar to KERMIT-32. Alow KERMIT to set the
- IBM handshaking character, incase the IBM character is something other
- than ^Q. Fix the IBM macro defined to set up the three parameters
- required for IBM transfers, this means to add in the setting of the
- handshake character. The kludge use of IBM-MODE is no longer needed,
- remove it.
-
- The changes are in Module KERMIT
- Page 3
-
- 4.0
-
- PATCH [134]
-
- Since the distribution files for KERMIT-10 are changed to
- K10???.???, lets make the source file names that in the first place.
- This requires that all search file names must be changed to K10???.
- The prologue in K10UNV should remain as KERMIT or else you won't be
- able to find the help file for KERMIT. Also there is a new help file
- which contains the SET HANDSHAKE and SET XON-XOFF-PROCESSING help.
- The help file also modifies the the SET IBM-MODE command to SET IBM
- which initiates the IBM macro.
-
- These changes were done to ALL Modules.
-